
ENGLISH
Dialogic® Diva® Media Board Installation Guide
page 67
• The application software shall comply with the following requirements
before the commencement of dialing:
• When dial tone detection is enabled, the application software may
commence dialing after the presence of dial tone is validated.
• If dial tone detection is not enabled or if dial tone is not detected, the
application software shall commence dialing no less than 2 seconds
after the line is seized.
• A total of 10 call attempts are allowed to a telephone number, with a
minimum period of 2 seconds between calls. If the call does not connect
after 10 attempts, 30 minutes must expire before automatic redialing may
be initiated.
• These products must connect to the telecommunications network only by
means of cables that meet applicable ACA standards and
telecommunications conformity.
• These products must only be used in a data terminal equipment (DTE),
e.g., computer, that has a screw-down cover or lid. Because unsafe voltages
(TNV) exist on these products, disconnect the product from the telephone
line while the cover of the DTE is removed.
Note: This does not apply to Dialogic
®
Diva
®
V-xPRI PCIe HS and V-xPRI
PCIe FS Media Boards.
• These products will not automatically put the channel back to the on-hook
state when the calling party hangs up. The application is tasked to handle
this function on the detection of a disconnect tone or loop current drop.
Regulatory information for Japan
Product Certificate Number
Diva BRI-2
Diva UM-BRI-2
CD-02-0870JP
Diva 4BRI-8
Diva UM-BRI-2
C01-0472JP L01-0152
Diva PRI/E1/T1-CTI
Diva PRI/E1/T1-8
CD05-0558001
Diva PRI/T1-24
Diva PRI/T1-24 PCIe
CD05-0557001
Diva V-2PRI CD06-0488001
Diva V-4PRI CD06-0489001
Diva Analog-4
Diva Analog-8
Diva UM-Analog-4
Diva UM-Analog-8
A05-0055003
Komentáře k této Příručce