Dialogic 4000 Series SU4.1 Uživatelský manuál Strana 42

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 226
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 41
Dialogic 4000 Media Gateway Series SU4.1 Reference Guide
34
EarlyB3
default
disconnect
timeout [s]:
Specifies the disconnect timeout value for early media calls to the PSTN,
depending on the received cause value. The disconnect timer is released if a
call to the PSTN is terminated before the receiver answers the call. This allows
the caller to listen to a network announcement describing the reason for the
failure (e.g., "The number you have dialed is not available. Please try again
later.")
The default value is 30 seconds. This value also applies to all causes not listed
in the Enhanced section.
EarlyB3
disconnect
timeout [s]
Cause
<x>:<reason
for
disconnect
timeout>:
With these parameters, you can define the disconnect timeout for the
different disconnect timeout reasons. The default value for each reason is 30
seconds.
Address Normalization
You can configure the following parameters in the Address Normalization section when
you create or modify a PSTN interface:
Dialplan:
Select the local dialplan to be used by the dialplan module of Diva
SIPcontrol. The selected dialplan applies only to this controller.
In most cases, the PSTN interfaces within the system share a common
dialplan of the local environment, but configuring the dialplan per
controller allows for handling variants, e.g., if the controllers are
connected to different PBXs or if one controller is directly connected to
the public network.
Configure the local dialplan as described under Dialplans before you
select it here.
Zobrazit stránku 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 225 226

Komentáře k této Příručce

Žádné komentáře