
80
Chapter 6 Command Definitions
6.6.2 C7LSC – CCS SS7 Link Set Change
Synopsis
This command allows changes to the configuration of an SS7 link set.
Syntax
C7LSC:LS=,{[OPC=,][DPC=,][LSSIZE=,][NC=,][NI=,]};
Prerequisites
• The SS7 link set has already been initiated.
• All configured SS7 links must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
• The LSSIZE cannot be set to less than the number of links attached to the link set.
• DPC must be different across link sets.
• If SS7MD indicates a 14-bit Point Code, OPC and DPC must be less than or equal to 16383.
• Only one OPC can exist within a network context.
• The NC/DPC combination must be different for all link sets.
• The NC/OPC combination must be different for all link sets.
Attributes
CONFIG
Examples
C7LSC:LS=1,OPC=1,DPC=2,LSSIZE=2;
6.6.3 C7LSE – CCS SS7 Link Set End
Synopsis
This command is used to end the SS7 link set.
Syntax
C7LSE:LS=;
Prerequisites
• There should be no signaling links attached to the link set.
• All configured SS7 links within the system must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
• There are no C7 Routes using this link set.
Attributes
CONFIG
Examples
C7LSE:LS=1;
Komentáře k této Příručce