Dialogic DSI SS7MD Uživatelský manuál stáhnout pdf (Strana 111)

111

Dialogic

DSI Signaling Server SGW Mode User Manual Issue 5

6.12.6 SGIRC – Signaling Gateway Incoming Route Change

Synopsis

This command changes the configuration of a Signaling Gateway incoming route.

For RKTAB/DEST, a value of “null” is supported. “null” indicates a wildcard value and means any value. “null”

is the default value for an RKTAB/DEST entry.

Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly

specified in the command.

Syntax

SGOPC:IR=,[RKTAB=,][DEST=,][LABEL=];

Prerequisites

• The incoming route already exists.

• If specified, the destination index exists.

• The NC/DOMAIN combination has already been initiated.

• Either an RKTAB or DEST must exist.

Attributes

CONFIG

Examples

SGIRC:IR=1,DEST=5;

6.12.7 SGIRE – Signaling Gateway Incoming Route End

Synopsis

This command ends the configuration of a Signaling Gateway incoming route.

Syntax

SGIRE:IR=;

Prerequisites

• The incoming route already exists.

Attributes

CONFIG

Examples

SGIRE:IR=1;

6.12.8 SGIRP – Signaling Gateway Incoming Route Print

Synopsis

This command prints the configuration of a Signaling Gateway incoming route.

Syntax

SGIRP:[IR=];

Prerequisites

• If specified, the IR has already been initiated.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 175 176

Žádné komentáře

Dialogic DSI SS7MD Uživatelský manuál Strana 111