
Initial Configuration and License Activation
Page 15
3. If your PPC is valid, the following web site will open:
Paste your Device Unique ID (DUID) that you saved earlier, and enter your email address to which the license
file should be sent.
4. Click Activate to generate the license file that will be sent to the email address you have entered.
5. Save the license file and activate it. For more information, see To Activate the License File
below.
To Activate the License File
Note: The date set in the system settings of your computer must be correct. Otherwise, you cannot add your
license file.
1. Click License Management on the left side of the Diva SIPcontrol web interface to open the License Status
dialog.
2. In the License Status dialog, click Browse, go to the directory in which you saved the license file, and
click Open.
3. Click Upload to activate the license file.
Important Note
The Dialogic
®
4000 Media Gateway SBA is shipped with automatic updates disabled. Customers are strongly
advised to double-check their deployment and ensure that the domain WSUS service is properly configured NOT
to install Windows Service Packs on the SBA device. Applicable Microsoft Service Packs are scheduled to be
included as part of future Dialogic
®
4000 Media Gateway updates.
For example, if automatic updates are turned on, and Windows 2008 R2 Service Pack 1 is applied to a Dialogic
®
4000 Media Gateway that is being used as an SBA, a boot failure can occur. This type of failure will require
intervention by the administrator to restore the unit's operation. For more information, see
http://www.dialogic.com/support/helpweb/mg/iw2756.aspx
.
Komentáře k této Příručce