Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Uživatelský manuál stáhnout pdf (Strana 41)

Basic Site Configuration

This procedure is a list of actions to do in order to basically configure your Site after installing the fax server.

To know precisely how to perform them, and for more information about the related concepts, please refer

to the XMediusFAX Administrator Guide.

1. Log into the administration interface and access the Configuration section of your site.

2. In the Profiles node, create and setup profiles according to your needs (list of cover sheets, CSID and

security).

3. In the Users node, create or import users as required.

4. In the Incoming Routing Table node:

a) Set the properties of the Default Rule and enter the address to use for misrouted faxes.

This is usually the fax administrator’s e-mail address.

b) Set the incoming routing table by creating and configuring routing rules.

For example: associate DNIS to a list of destinations, most likely the e-mail address of a user.

5. In the General Settings node, access the Properties:

a) Click the General tab to configure the Incoming Fax Notifications and the Rasterization Options.

b) Click the SMTP tab to set the Feedback Address (in case of transmission failure) for the gateway for

SMTP and to add, if needed, Trusted Mail Servers.

The Feedback Address is usually the fax administrator’s e-mail address.

Basic System Configuration

This procedure is a list of actions to do in order to basically configure the system side of your fax server. To

know precisely how to perform them, and for more information about the related concepts, please refer to

the XMediusFAX Administrator Guide.

1. Log into the administration interface as a system administrator and access the Configuration section of

the system.

2. In the Driver ➤ Channels node of your host:

a) Access the Properties of each channel.

b) Review the mode settings: Inbound, Outbound or Both.

3. In the SMTP Gateway node of your host:

a) Access the Properties.

b) Review the current gateway for SMTP settings.

We recommend that an external dedicated server be used for relaying mail.

4. In the Modification Table node:

a) According to your local dial plan, add new items to the table and configure them.

b) Setup the modification table to properly handle local calls, then test it.

5. If needed, create a new site and configure its properties.

For a basic configuration of this site, see Basic Site Configuration on page 31.

b) Add the entry for the new site on the system routing table by specifying the DNIS ranges associated

with that site.

XMediusFAX | Installation and Maintenance Guide 31

Chapter 4 | Basic Configurations

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 101 102

Žádné komentáře

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Uživatelský manuál Strana 41