Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Uživatelský manuál stáhnout pdf (Strana 40)

2. Configure the concerned service to log on using the account you have granted administrative privileges:

a) Access the Windows services management interface (i.e. Start ➤ Run ➤ services.msc).

b) Locate the concerned service (e.g. XMDocumentRasterizer or XMSMTPGateway) and edit its

properties.

c) Under the Log On tab, select This account and enter the information of the administrative account

you just created.

d) Restart the concerned service.

Setting a Pre-Initialized Office Environment for the Rasterizer

1. If you have Office 2007 installed on the server, ensure that you have applied at least Service Pack 1.

2. Log out of Windows and log in using the administrative account that you have set to run the

XMDocumentRasterizer service (see Associating a Service with a Windows Admin Account on page

29).

3. Open MS Word and MS Excel to ensure that no Welcome screen or error messages occur.

Note: It is not likely that any error will occur; however these applications must not display any prompt

message when they are started, otherwise the Rasterizer will not work properly.

4. Once you have resolved any prompt or error messages, reboot the server.

Installing the License and Setting the Channels

How to manually install the license and set the fax driver channels after the server installation.

XMediusFAX offers the possibility to install the license during the server installation. If you did not choose to

do so, it is possible to process manually through the administation interface.

1. Log into the fax system administration interface and browse to: General Settings ➤ Properties.

2. Select the License tab and click Update.

3. Browse for the new license file you received, select it and confirm.

4. Click OK.

5. Restart the XMFaxDriver.

6. If needed, check and adjust the settings related to your fax channels:

• Driver ➤ Properties ➤ Options ➤ T.38 Channel Configuration: the Maximum Number Of Channels

must have been automatically updated (by the Driver service restart) in accordance with the new

license.

Note: If you have more than one driver installed, you can adjust the Preferred Number Of

Channels for each driver.

• Driver ➤ Channels ➤ [Channel] ➤ Properties: you can set the channel mode (Receive, Send or

Both) for each available channel.

• Sites ➤ [Site] ➤ Properties ➤ Quality of Service ➤ Connections: if you are using more than one

site, you can adjust channel quotas for each site.

30 XMediusFAX | Installation and Maintenance Guide

Chapter 4 | Basic Configurations

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 101 102

Žádné komentáře

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Uživatelský manuál Strana 40