Dialogic 2000 Series Uživatelský manuál stáhnout pdf (Strana 7)

Configuring the Dialogic Media Gateway Configuring the Dialogic Media Gateway

- Backup Proxy Server Address: Leave blank.

• Monitoring

- Monitor Call Connections: Select No using the drop-down menu.

Configuring the Routing Tables

The routing table describes a set of rules used to define the characteristics of a call routed through the

media gateway. The primary characteristics include the destination address and the calling party

identification (CPID) information. The routing table affects calls originating from the Voice over Internet

Protocol (VoIP) side, and calls originating from the time-division multiplexing (TDM) (T1, E1, analog,

etc.) side. The following steps are required to configure the routing tables:

1. Configuring the TDM Trunk Group on page 7

2. Configuring a VoIP Host Groups on page 8

3. Configuring the Inbound TDM Rules on page 9

4. Configuring the Inbound VoIP Rules on page 12

Configuring the TDM Trunk Group

The TDM trunk group will be used to route calls between the attached PBX and NetVanta UC Server.

Using regular expressions or wildcard characters you can define the range of ports that you will use for the

TDM trunk group.

To configure the TDM trunk group, follow these steps:

1. Using the menu on the left, navigate to Configure > Routing Table. The Router Configuration menu

will appear.

2. Select the TDM Trunk Groups radio button.

3. Ensure there is an entry for both voice and message waiting ports. If the entries do not exist, select the

Add Trunk Group button to add new trunk groups.

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Žádné komentáře

Dialogic 2000 Series Uživatelský manuál Strana 7