Dialogic 2000 Series Uživatelský manuál stáhnout pdf (Strana 3)

4.1.2 Connecting with Ethernet

• Connect gateway to Network using LAN 1.

• Configure computer connecting to the gateway on the 10.12.13.x subnet (e.g.

10.12.13.75) and subnet mask of 255.255.255.0.

• Use telnet and connect to gateway at 10.12.13.74.

4.2 Initial Gateway Configuration

• Configure initial gateway. Press Enter key until you get to the “PIMG” prompt. Follow the

steps below and modify the settings in red to match your environment. The values in

bold are what you will be entering.

• Clear ARP Table on computer connecting to gateway (e.g. on Windows

machine,

the command is “arp -d*” from a Command Shell).

• Change the IP address on the computer connecting to the gateway to match the

newly configured gateway IP address.

4.3 Parameter Configuration

To get the gateway connected to the PSTN for use with IBM Lotus Sametime Unified Telephony,

there are a few configuration options that are required. During the solution-specific setup of the

Dialogic

gateway using the web interface, you must:

PIMG> pw

Enter Password: IpodAdmin

Admin level accepted.

PIMG-admin> quickcfg

LAN 1 IP Address[10.2.2.3] : (Enter new IP Address

LAN 1 Subnet Mask[255.255.255.0] : (Enter new Subnet Mask)

LAN 1 Default Network Gateway Address[10.2.2.5] : (Enter new Default

Network Gateway Address)

LAN 2 IP Address[10.2.2.2] :

LAN 2 Subnet Mask[255.255.255.0] :

Select Line Mode ...

Valid entries:

1. T1

2. E1

Enter Number for Line Mode Selection [T1] : 1

Select Protocol ...

Valid entries:

1. CAS - Loop Start

2. CAS - Ground Start

3. CAS - E&M Immediate

4. CAS - E&M Delay

5. CAS - E&M Wink

6. ISDN - QSIG

7. ISDN - NI-2

8. ISDN - 5ESS

9. ISDN - DMS-100

Enter Number for Protocol Selection [ISDN - NI-2] : 7

Saving parameters now...

Parameters successfully configured!

******* Restart Required ******* (Type 'restart')

PIMG-admin> restart

rebooting...

1 2 3 4 5 6 7 8 ... 11 12

Komentáře k této Příručce

Žádné komentáře

Dialogic 2000 Series Uživatelský manuál Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače Dialogic 2000 Series